The basic precision settings found for each camera in camera managment dialog.
Here we need to define standard precision instead of fine pitch settings to allow chips get aligned without angle alignment (disable A).
If precision settings too tight, parts get dropped often!

Normally we should use Precision XY=3 and Precision A=3. In some cases maybe wider settings needed!

Standard local precision settings in feeder settings are Precision XY=-1 and Precision A=-1 to disable local precision settings.
System will use basic settings from camera setup.

If parts need fine pitch adjustment add Precision XY=2 and Precision A=1 or maximum Precision XY=1 and Precision A=1 to feeder settings.

A special is SOT-23 valid settings are Precision XY=4 and Precision A=10 for this component type.