VISION PLACER Hardware questions » Push feeder problem

SMALLSMT Forum � Hardware questions � VISION PLACER Hardware questions � Push feeder problem

Topic settings

Jump to forum

Forum SMALLSMT Forum Hardware questions VISION PLACER Hardware questions SMT VISOR Hardware questions HR-300 Reflow Oven Found on the internet Vision Placer software Vision Placer software V2 & V1 Vision Placer V2 Bug List Tips & Tricks DotMaker Software PnPCreator Common area SMT related questions User talk Marketplace Electronics Kendryte K210 RISC-V Controller

#1 | Push feeder problem datum

Tue Sep 07, 2021 10:45 pm

One of my push feeders appears to cycle OK but won't lower the nails. I have taken it apart a bit and somehow it seems the feeder is locked up.
The nails definitely don't want to descend. I'm dissassemling it further now.

Any advice?

reply

#2 | RE: Push feeder problem datum

Wed Sep 08, 2021 6:39 am

Maybe you check the section in manual how to adjust the brakes?

Forum admin email: michael@smallsmt.biz

reply

Z axis problem � � Stepper Driver Current Settings

Related topics

Replies

Last post

Modular feeder jams or becomes out of sequence with large components when using multiple heads for pickup.
Created in forum Vision Placer software V2 & V1 by corvidae

Mon Aug 29, 2022 9:20 am
von

mbruch • Views: 166

Machine continuously ejects part when "Push Count = 0"
Created in forum Vision Placer V2 Bug List by corvidae 3 Thu Aug 04, 2022 10:48 am
mbruch • Views: 244
W-Pushfeeder stopped working, needed adjustment [Push feeder arm Z limit adjustment]
Created in forum VISION PLACER Hardware questions by Louis 1 Fri Mar 06, 2020 5:57 pm
mbruch • Views: 414
Vibration Feeder does not stop
Created in forum VISION PLACER Hardware questions by solar 3 Tue Jan 21, 2020 11:34 am
solar • Views: 533
Software bug? Feeder test advances cover tapes before walking
Created in forum VISION PLACER Hardware questions by hbridge 3 Mon Aug 26, 2019 11:29 am
Louis • Views: 441
Vision Problem?
Created in forum VISION PLACER Hardware questions by hbridge 2 Mon Aug 19, 2019 3:07 am
hbridge • Views: 435

The manual mentions "needle valves" and has a kind of confusing picture with arrow pointing to the push feeder.
Created in forum VISION PLACER Hardware questions by hbridge

Wed Aug 21, 2019 7:56 am
von

mbruch • Views: 402

CL feeder feed problems caused by low air pressure supply
Created in forum VISION PLACER Hardware questions by mbruch 0 Fri Mar 15, 2019 12:56 pm
mbruch • Views: 613
Problem with placement stopping permanently in the middle of a run
Created in forum Vision Placer software V2 & V1 by MtnMan 11 Thu Aug 10, 2017 7:58 am
mbruch • Views: 1209

SMALLSMT Forum

Please enter a reason for warning.