Hi,

I am testing our new machine with V2 software and trying to align the pcb using manual mark points.

The board is circular and the origin is at the center of the board.

I added two mark points from pcb-desing (mounting holes) and then jog the head to the actual mounting hole positions and capture the results.

pcb-dialog.PNG - Bild entfernt (keine Rechte)

However, entering those Mark offsets and checking the "Using manual mark point set!" seems to have no effect.

"Move camera to part coordinate" shows the nominal positions without any correction. And running the actual placement shows exactly the same result as not using markpoints at all.

But with automatic mark detection with head-camera the placement runs just fine.

So, how the "using manual mark point set" should work?

-
Heikki