#1 Show Vacuum Test Value with "Pick To bottom Camera"? by tingo 23.07.2019 16:26

Hello,
Is there a way to have the software (V2) show the vacuum test value when you do "Pick To Bottom Camera"?
So far it sems that the software only reports this value when you actually (test) mount a part.

#2 RE: Show Vacuum Test Value with "Pick To bottom Camera"? by mbruch 23.07.2019 16:36

avatar

I think you only need to check the value in white status message left bottom side. I can’t check now because of holidays trip.

Xobor Einfach ein eigenes Forum erstellen
Datenschutz