Hello,

How would I go about setting A2 to decend further when trying to pick up a nozzle? It does pick it up, but isn't going deep enough so the nozzle doesn't lock in.

I've previously followed section 6.5 in the manual to setup Nozzle_Y_Exit on all nozzles in the cart, so I think maybe this happens because of the changed Nozzle_Z_Exit.

The meaning of Nozzle_Z_Exit isn't clear to me after reading 6.5 and 6.3:
In 6.5, Nozzle_Z_Exit is set for each nozzle to Z=top of part surface of an arbitrary feeder line (same feeder used for all nozzles).
6.3 says "Nozzle Z_Exit is the up position."
-->what is that supposed to mean?
Also: "In down Z position the nozzle need to be adjusted to the bottom side of the nozzle holder.".
--> What's the "down Z position"?

Can you clarify this?

Thanks in advance+kind regards,
gj