RE: The machine does not work after new software (BEEP, chaotic and other problems)

SMALLSMT Forum � Vision Placer software � Vision Placer V2 Bug List � The machine does not work after new software (BEEP, chaotic and other problems)

Page 2 of 2 � Page 1 2 Page �

Topic settings

Print view

Jump to forum

Forum SMALLSMT Forum Hardware questions VISION PLACER Hardware questions SMT VISOR Hardware questions HR-300 Reflow Oven Found on the internet Vision Placer software Vision Placer software V2 & V1 Vision Placer V2 Bug List Tips & Tricks DotMaker Software PnPCreator Common area SMT related questions User talk Marketplace Electronics Kendryte K210 RISC-V Controller

#16 | RE: The machine does not work after new software (BEEP, chaotic and other problems) datum

Thu Jan 28, 2021 9:05 pm (Last edited: Thu Jan 28, 2021 9:08 pm)

Zitat
Yes, i use USB cable extension. 3 meters.

Remove USB cable extension first!

The maximum length for USB 2.0 cables that comply with the standard is 5 metres according to the specification.
Longer cables can be used if they are made of high-quality materials.
Hubs or active repeaters must be used for longer transmission paths.

Forum admin email: michael@smallsmt.biz

reply

#17 | RE: The machine does not work after new software (BEEP, chaotic and other problems) datum

Thu Jan 28, 2021 9:11 pm (Last edited: Thu Jan 28, 2021 9:11 pm)

I checked. Didn't help. I will try to check with a notebook (i started to work with my SMT on a laptop)
At this moment i use PC.

reply

#18 | RE: The machine does not work after new software (BEEP, chaotic and other problems) datum

Mon Feb 01, 2021 9:49 am

i found an old laptop (I tested the SMT on it when the SMT arrived to me). i checked different wires. and i can say that the my SMT dosen't work.
This video on the old laptop with old software:
https://www.youtube.com/watch?v=nlTrbjdO...channel=alexbbs

I think that the board is broken. Can i reupload firmware on it?

reply

#19 | RE: The machine does not work after new software (BEEP, chaotic and other problems) datum

Mon Feb 01, 2021 10:08 am (Last edited: Mon Feb 01, 2021 10:09 am)

I think you need to chack the vaccum sensor readouts.
One option you didn't adjust vacuum check levels well.
If nozzle changer used need to adjust in nozzle list.
If not need to adjust in feeder settings.

Check the vaccum sensor values if vacuum turned on and nozzle open / close and report to me please.
And send the message shown in status field left bottom side white box!

Forum admin email: michael@smallsmt.biz

reply