Hello, on my machine a manual homing procedure does only the mechanical homing, it does not use the optical homing.
That should be included.

Also, it would be very nice to have a way to tell the software to repeat an optical homing procedure. There is no way to do that now.
I often have failures in the optical homing, it tries, but does not end it, the head stand still on the optical homing point then.
Since I do not have a way to repeat it I then habe placements offsets.

So please ad a way to do it, thank you.

That is enabled. It does a opical homing after a job was finished. But sometimes it fails. I have no way to repeat that optical homing then.
When I click on "Reset origin" it does only a mechanical homing.

Everything else works as expected.

As I said: On pressing "Reset origin" it does only do a mechanical homing.
The machine does not even try to do an optical homing.

Only when connect the software and after ending a job it does an optical homing procedure.

is that normal?



Software is 2.053 but I had this from start, I never could do a manual optical homing.

Here are the settings.
And I did a clean startup, machine does a reference and goes to optical home.
It tried but did not succeed. Only after the 3rd try it did one.

The dot ist perfect, but it does not work reliable.
Oh, and I have no status output or something like that. Where should that be?

It would just be a very nice feature if you please would just add a way to do a manual optical homing in one of your large menus.
It is not that difficult. Just a nice option for thos who need it.

I tried the newest version. Now I get an output:

60->Start
60->Start
60->Finish
60->Finish
VisualOrigin: X = -0.0189，Y = 0.0479，D = 1.1729
VisualOrigin: X = -0.0258，Y = 0.0129，D = 1.1835
VisualOrigin: X = -0.0378，Y = -0.0111，D = 1.1855
VisualOrigin: X = -0.0323，Y = 0.0000，D = 1.1980
VisualOrigin: X = -0.0323，Y = 0.0000，D = 1.1980
VisualOrigin: X = -0.0323，Y = 0.0000，D = 1.1980
VisualOrigin: X = -0.0323，Y = 0.0000，D = 1.1980
VisualOrigin: X = -0.0420，Y = -0.0119，D = 1.1891
VisualOrigin: X = -0.0420，Y = -0.0119，D = 1.1891
VisualOrigin: X = -0.0378，Y = -0.0111，D = 1.1855


After that I get an error: "Visual Origin X-coordinate overrun!"

Now I do not have a visual origin at all :-(

It is in fact on the same exact position as the factory made point.
I only made it better as the factory provded point was a piece of pcb with HAL on it, the contrast was very bad.

Video and files are underway-